Revel S12 Bedienungsanleitung PDF herunterladen (Seite 17)

17

REVEL Concerta S12

Owner’s Manual

STANDARD CONNECTIONS

Standard connections are made as shown

in Figure 17 (above).

To make standard connections:

1. Leave the shorting-straps in place.

2. Connect one pair of loudspeaker wires

to the S12 input connectors. Then, con-

nect the same pair of loudspeaker wires

to the desired power amplifier outputs.

Note

In addition to the polarity symbols under-

neath the terminals, the binding posts also

have red (positive) and black (negative)

inserts to indicate polarity. Be sure to

observe proper polarity, especially when

inverting the right side speaker(s), to

ensure proper connections. In Figures 18

and 19 the polarity of the input connec-

tors are all labeled for clarity.

DUAL-SPEAKER MODE

CONNECTIONS

Dual-speaker mode connections are made

as shown in Figure 18 (below) and 19 (next

page).

To make dual-speaker mode connections

when a single S12 is used as discrete

left/right rear loudspeakers:

1. Remove the shorting-straps.

2. Connect one pair of loudspeaker wires

to the top set of input connectors.

Then, connect the same pair of loud-

speaker wires to the left rear amplifier

output.

3. Connect one pair of loudspeaker wires

to the bottom set of input connectors.

Then connect the same pair of loud-

speaker wires to the right rear amplifier

output as shown in Figure 18 (below).

Note

Set the Surround Mode Configuration

control to Bipole for proper operation.

CAUTION

Failure to remove the shorting straps

may damage the associated power

amplifier.

Figure 17: Standard Connections

Figure 18: Dual-Speaker Mode Connection for a

single S12 used as discrete rear channels

Left Rear

Right Rear

Right Rear

Speaker

Left Rear

Speaker

For Dual-Mode discrete

rear channels, the S12

should be placed in the

center of the rear wall.

Amplifier

S12

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare