Revel S12 Bedienungsanleitung PDF herunterladen (Seite 16)

16

REVEL Concerta S12

Owner’s Manual

Wall-Mounting Instructions

(continued)

4. Make speaker connections, as described

in the Making Connections section

(below).

5. Place the speaker on the wall by align-

ing the upper two keyholes on the back

of the speaker to the screwheads on the

wall. Once positioned properly, the

loudspeaker should slide down slightly

and become securely mounted.

MAKING

CONNECTIONS

The S12 features gold-plated binding posts

that accomodate heavy-gauge speaker

wire.

CAUTION

Never make or break connections

unless all system components are pow-

ered off.

Before making connections, note the

following:

• Make all connections observing the

proper polarity, positive-to-positive (+)

and negative-to-negative (–).

Connections that do not observe the

proper polarity will cause poor stereo

imaging and diminished bass response.

• Review the owner’s manuals for

associated audio components to

determine their connection procedures.

• If you have questions about the suit-

ability of associated power amplifier com-

ponents, contact an authorized Revel

dealer for information.

• Use high-quality loudspeaker cable

with a maximum total loop resistance

of 0.07ohms or less (for each wire run).

Refer to the table on the next page to

determine the appropriate maximum

wire gauge.

Maximum Wire Gauge

Gauge Length Length

(AWG) (Feet) (Meters)

687 27

769 21

858 18

943 13

10 34 10

11 27 8

12 22 7

13 17 5

14 14 4

15 11 3

16 9 3

17 7 2

18 5 2

Note

High loop resistances that exceed 0.07ohms

(for each wire run) will cause the filter

network to mis-terminate, resulting in

considerable degradation of sound quality.

• The standard connection method uses

a single pair of input connectors with

the shorting-straps in place. The S12 is

equipped with two pairs of input termi-

nals to allow for using a single S12 as

two independent speakers (dual-speak-

er mode). Please note that when using

a single S12 for discrete channels (dual

speaker mode), you must remove the

shorting-straps.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare